ABOUT INDEXING EDITORIAL BOARD ARCHIVES AUTHOR GUIDELINES SUBMIT PAPER NEWS, EVENTS AUTHOR'S PAGE CONTACT
Materiale Plastice
Cite as: Mater. Plast.
https://doi.org/10.37358/Mat.Plast.1964

OSIM Nr. R102356
ISSN Print 0025-5289
ISSN Online 2668-8220
Materiale Plastice - Latest Issue

Latest Issue >>>
ARCHIVES
   Volume 61, 2024
   Volume 60, 2023
   Volume 59, 2022
   Volume 58, 2021
   Volume 57, 2020
   Volume 56, 2019
   Volume 55, 2018
   Volume 54, 2017
   Volume 53, 2016
   Volume 52, 2015
   Volume 51, 2014
   Volume 50, 2013
   Volume 49, 2012
   Volume 48, 2011
   Volume 47, 2010
   Volume 46, 2009
   Volume 45, 2008
   Volume 44, 2007
   Volume 43, 2006
   Volume 42, 2005
   Volume 41, 2004
   Volume 40, 2003
 
<<<< back

Materiale Plastice (Mater. Plast.), Year 2010, Volume 47, Issue 1,





Camelia Cerbu, Ioan CURTU, Vasile CIOFOAIA, Ioan Călin ROSCA, LUCIAN CONSTANTIN HANGANU Effects of the Wood Species on the Mechanical Characteristics in Case of Some E-glass Fibers/Wood Flour/Polyester Composite Materials


Abstract:
The paper describes some aspects concerning the effects of the type of wood species on some mechanical characteristics of some hybrid composite materials reinforced with both E-glass woven fabric and wood flour. It also shows the effects of the moisture absorption on the mechanical behaviour in bending after immersion in two different environments: water and seawater. The specimens were manufactured by reinforcing a polyester resin Copoly 7233 with both E-glass woven fabric EWR145 and wood flour. Two kinds of wood flour, oak wood flour and fir wood flour were used to manufacture the two composite materials tested. The immersion time was approximately eight months. The quantity of the moisture absorbed was greater in case of the immersion in water than in case of the immersion in seawater. Then, the both dried specimens and the wet ones were subjected to flexural tests by using the method of the three points. Finally, the experimental results obtained were analysed in terms of the nature of the immersion environment. Moreover, it was analysed the effect of the immersion time on the changing of the mechanical characteristics in case of woven fabric / oak wood flour / polyester. Finally, the paper recommends the using of the oak wood flour in case of the parts made of composite material analysed, that works in humid environment excepting the case when its salt content is greater. Keywords: hybrid composite; wood flour; absorption; flexural test



Issue: 2010 Volume 47, Issue 1
Pages:
download pdf   Download Pdf Article
Creative Commons License
This article is published under the Creative Commons Attribution 4.0 International License


Downloads number: 0
<<<< back
 
  Search Authors
Crossref Member Badge
 DOI  logo
 Gold Open Access | Source=http://www.plos.org/  | Author=art designer at PLoS
Creative Commons License